Home
Precision Machining
Industrial Rollers
Urethane
Wire Drawing Dies
Contact Us
Job Openings
About us
     
 

                            This page is under construction


Please call 25-841-8400   for information on Wire Drawing Dies or see WireDrawingDies@YolaSite.com.   Please choose another tab if you are interested in precision machine work or rubber industrial rollers.


Tungsten Carbide Wire Dies
Precision Die Service (now know as Dixie Precision has provided America's Wire Industry with Wire Drawing Dies since 1970  We have refurbished over 2 million dies in the last 40 years.

Our die shop's only focus is the old fashioned tungsten carbide round wire drawing dies.   These are known in the industry by several names,including  "carbide dies",  "round dies", "regular dies" and "traditional dies".  We offer new cores as well as several die reworking programs. i.e  recuts,  recutting, finish & finishing  We refer to these programs as lease and exchange.  

We polish and size, resize and  tungsten carbide wire dies.   Dixie  Precision can provide you with rough cores.  We also have a finished wire drawing dies, and a wire die recutting program

Wire drawing dies  wire dies carbide nibs  R4 R5 R6 R7 R8 R9 R10l  R11 cases 


 
Questions about Dies and Wire Drawing?

http://en.wikipedia.org/wiki/Wire_drawing

Drawing dies are typically made of
tool steel, tungsten carbide, or diamond, with tungsten carbide and manufactured diamond being the most common.[2] Synthetic diamond is usually used in the early stages of the drawing process, whereas natural diamond dies are used in the final stages.[citation needed] For drawing very fine wire a single crystal diamond die is used.[2] For hot drawing, cast-steel dies are used.[citation needed] For steel wire drawing, a tungsten carbide die is used.[citation needed] The dies are placed in a steel casing, which backs the die and allow for easy die changes.[2] Die angles usually range from 6–15°,[citation needed] and each die has at least 2 different angles: the entering angle and approach angle.[2] Wire dies usually are used with power as to pull the wire through them. There are coils of wire on either end of the die which pull and roll up the wire with a reduced diameter.

   What is Wire Drawing?

S
ci-Tech Encyclopedia: Wire drawing

Home > Library > Science > Sci-Tech Encyclopedia



The reduction of the diameter of a metal rod or wire by pulling it through a die. The working region of dies are typically conical (see illustration). The tensile stress on the drawn wire, that is, the drawing stress, must be less than the wire's yield strength. Otherwise the drawn section will yield and fail without pulling the undrawn wire though the die. Because of this limitation on the drawing stress, there is a maximum reduction that can be achieved in a single drawing pass. After large drawing reductions, wires or rods develop crystallographic textures or preferred orientations of grains. The textures are characteristic of the crystal structure of the metal.

 Home > Library > Miscellaneous > Britannica Concise Encyclopedia

 

Making of wire, generally from a rod or bar. The wire-drawing process consists of pointing the rod, threading the pointed end through a die, and attaching the end to a drawing block. The block, made to revolve by an electric motor, pulls the lubricated rod through the die, reducing it in diameter and increasing its length. Fine wire is made by a multiple-block machine, because the reduction cannot be performed in a single draft.

For more information on wire drawing, visit Britannica.com




We are currently creating content for this section. In order to be able to keep up with our high standards of service, we need a little more time. Please stop by again. Thank you for your interest!